REAR DOOR SPEAKER REMOVAL


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    1. A01JA8O

      Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.

  2. REMOVE DOOR ASSIST GRIP COVER


    1. A01JAP6

      Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the door assist grip cover.

  3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A01JBGI

      Disengage the 7 claws and 2 guides.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  4. REMOVE REAR DOOR ARMREST COVER


    1. A01JBG5

      Remove the rear door armrest cover.

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01JCQBE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the rear door panel.

    2. A01JC69

      Remove the 2 screws.

    3. Using a clip remover, disengage the 8 clips.

    4. Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.

    5. Raise the rear door trim board sub-assembly and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.

    6. A01J8OM

      Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

    7. for 8 Speakers:


      1. Disconnect the connector.

  6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)


    1. A01J9DZ

      Remove the 2 screws and rear No. 2 speaker assembly.

  7. REMOVE REAR SPEAKER ASSEMBLY


    1. A01JC4B

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.