FRONT DOOR SPEAKER REMOVAL


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. A01JB2W

      Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel plug.

  2. REMOVE ASSIST GRIP COVER


    1. A01J8SJ

      Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the assist grip cover.

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. A01JCY6

      Disengage the 7 claws and 3 guides.

    2. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. A01JACF

      Disengage the 7 claws and 3 guides.

    2. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.

  5. REMOVE DOOR ARMREST COVER


    1. A01JCMQ

      Remove the door armrest cover.

  6. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01J8PYE01

      Using a moulding remover, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01JAQ1E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door panel.

    2. A01J8I7

      Remove the 2 screws.

    3. Using a clip remover, disengage the 9 clips.

    4. Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.

    5. Raise the front door trim board sub-assembly and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.

    6. A01JARO

      Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

  8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. A01JDBA

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 3 rivet heads and remove the front No. 1 speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.