STEERING WHEEL INSTALLATION


  1. INSTALL LOWER STEERING WHEEL BOSS COVER


    1. A01JCPK

      Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.

  2. INSTALL CRUISE CONTROL SWITCH WIRE

  3. INSTALL CRUISE CONTROL MAIN SWITCH


    1. A01JB9C

      Install the cruise control main switch with the 2 screws.

    2. A01J9XU

      Connect the connector.

  4. INSTALL STEERING PAD SWITCH ASSEMBLY


    1. A01J8O0

      Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.

    2. Install the 2 screws.

      Torque:
      2.4 N*m  { 25 kgf*cm, 21 in.*lbf }
    3. A01JCMK

      Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.

    4. Install the 2 screws.

      Torque:
      2.4 N*m  { 25 kgf*cm, 21 in.*lbf }

    5. Connect the steering pad switch connector to the spiral cable sub-assembly.

  5. INSTALL STEERING SHAKE DAMPER


    1. A01JAPN

      Install the steering shake damper to the steering wheel assembly with the 2 screws.

      Torque:
      2.4 N*m  { 25 kgf*cm, 21 in.*lbf }

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01JAID

      Rotate the spiral cable counterclockwise slowly by hand until it stops.

      Note

      Do not turn the spiral cable using the airbag wire harness.

    4. A01J9WYE01
      Text in Illustration
      *1 Alignment Mark

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      Note

      Do not turn the spiral cable using the airbag wire harness.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  8. INSTALL STEERING WHEEL ASSEMBLY


    1. A01JCUKE01
      Text in Illustration
      *1 Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect the connectors to the spiral cable sub-assembly.

  9. CHECK STEERING WHEEL CENTER POINT

  10. INSTALL STEERING PAD

    Click here