REAR BRAKE FLEXIBLE HOSE REMOVAL

Note

If both RH side hose and LH side hose are disconnected at the same time, be sure to place identification mark indicating the position on each side.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and setting. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISABLE BRAKE CONTROL


    1. Wait at least 2 minutes after the power switch off.

      Note

      When the brake pedal is depressed or the door courtesy switch is turned on even if the power switch is off, the brake control system activates. Therefore do not depress the brake pedal or open/close the doors until the reservoir level switch connector is disconnected.

    2. A01JAIJ

      Disconnect the reservoir level switch connector with the parking brake applied.

    3. Disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.

    5. Check that the brake pedal can not be further depressed.

    6. Release the parking brake.

  6. REMOVE REAR WHEEL

  7. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  8. REMOVE REAR BRAKE TUBE FLEXIBLE HOSE (for LH Side)


    1. Using a union nut wrench, disconnect the 2 brake lines while holding the rear brake tube flexible hose with a wrench.

      A01JAXG

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    2. Remove the clip, bolt and rear brake tube flexible hose.

  9. REMOVE REAR BRAKE TUBE FLEXIBLE HOSE (for RH Side)


    1. Using a union nut wrench, disconnect the 2 brake lines while holding the rear brake tube flexible hose with a wrench.

      A01JBA6

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    2. Remove the 2 clips and rear brake tube flexible hose.

  10. REMOVE REAR FLEXIBLE HOSE


    1. A01JAYW

      Using a union nut wrench, Disconnect the brake line while holding the rear flexible hose with a wrench.

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    2. A01JCHS

      Remove the clip and separate the rear flexible hose from the brake line.

    3. A01JAAE

      Remove the union bolt, gasket and rear flexible hose.