PARKING BRAKE PEDAL (for RHD) REMOVAL


  1. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  2. REMOVE FRONT SEAT ASSEMBLY LH

    Tech Tips

    Refer to the instructions for Removal of the front seat assembly Click here.

  3. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. REMOVE YAW RATE AND ACCELERATION SENSOR


    1. A01JCSV

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector from the yaw rate and acceleration sensor.

  5. REMOVE NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    1. A01JBGY

      Remove the 4 bolts and No. 2 belt anchor reinforcement sub-assembly.

  6. REMOVE NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    1. A01JCBY

      Remove the 4 bolts and No. 3 belt anchor reinforcement sub-assembly.

  7. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    1. A01JD5T

      Disengage the 2 claws to remove the No. 2 air duct sub-assembly.

  8. LOOSEN ADJUSTING NUT


    1. A01JD7RE01
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Remove the lock nut and loosen the adjusting nut.

  9. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. A01JCHZE01
      Text in Illustration
      *1 Turn
      *2 Hold

      Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.

  10. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. A01JB2U

      Remove the 5 bolts and separate the No. 1 parking brake cable assembly.

    2. Disengage the clamp.

    3. A01J9HP

      Disconnect the parking brake switch connector.

    4. Disengage the wire harness clamp.

    5. A01J956

      Remove the 2 bolts, nut and parking brake control pedal assembly.