ROCKER PANEL MOULDING REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE FRONT REAR WHEEL HOUSE PLATE LH

    A003DIW

    1. Using a clip remover, remove the clip.

    2. Remove the 2 screws.

    3. Detach the claw and remove the front rear wheel house plate.

  2. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY LH


    1. Remove the 3 screws.

    2. Remove the grommet and 7 retainers.

      A003BTME01
      Text in Illustration
      *1 Grommet *2 Retainer

    3. Put protective tape around the body rocker panel moulding.

    4. Remove the 2 screws.

    5. Detach the 8 clips and remove the body rocker panel moulding.

      A003E1SE01
      Text in Illustration
      *1 Protective Tape