HIGH MOUNTED STOP LIGHT ASSEMBLY (for Sedan) INSTALLATION

INSTALL CENTER STOP LIGHT ASSEMBLY
1. Attach the 4 claws to install the stop light.
2. Connect the connector.
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
1. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
2. Attach the 5 claws and 2 clips to install the package tray trim panel assembly.
3. Install the 4 clips.
INSTALL INNER ROOF SIDE GARNISH LH
Text in Illustration

*1 Clip A
1. Install 2 new clips labeled A to the inner roof side garnish.
2. Attach the 5 clips to install the inner roof side garnish.
INSTALL INNER ROOF SIDE GARNISH RH

Tech Tips

Use the same procedure described for the LH side.
INSTALL REAR SIDE SEATBACK ASSEMBLY LH
1. Install the claw as shown in the illustration.
2. Install the side seatback with the bolt.
  
  Torque:
  
  7.8 N*m { 80 kgf*cm, 69 in.*lbf }
3. Install the rear seat 3 point type belt anchor with the bolt.
  
  Torque:
  
  41 N*m { 418 kgf*cm, 30 ft.*lbf }
  
  Note
  
  Do not allow the anchor part of the rear seat 3 point type belt to overlap the protruding parts of the floor panel.
4. Install the seat belt to the belt guide.
5. Attach the claw to close the cap of the rear seat shoulder belt guide.
6. Check if the ELR locks.
  
  Note
  
  The check should be performed with the outer belt assembly installed.
  1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
INSTALL REAR SIDE SEATBACK ASSEMBLY RH

Tech Tips

Use the same procedure described for the LH side.
INSTALL REAR BENCH TYPE SEAT CUSHION ASSEMBLY
1. Attach the 2 rear hooks of the seat cushion to the seatback.
2. Attach the 2 front hooks to install the seat cushion.
3. Confirm that the seat cushion is firmly installed.
  
  Note
  
  When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.