FRONT WIPER MOTOR REMOVAL

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A00DSOB

      Remove the clip and engine room side cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WIPER ARM HEAD CAP


    1. A003BEK

      Using a screwdriver, remove the front wiper arm head cap.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for all front wiper arm head caps.

  4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A003CFU

      Remove the nut and the front wiper arm and blade assembly LH.

  5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A003C4X

      Remove the nut and the front wiper arm and blade assembly RH.

  6. REMOVE HOOD TO COWL TOP SEAL


    1. A003BK8

      Using a clip remover, detach the 6 clips and 2 claws and remove the hood to cowl top seal.

  7. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A003CSY

      Remove the clip.

    2. Detach the 8 claws and remove the cowl top ventilator louver RH.

  8. REMOVE COWL TOP VENTILATOR LOUVER LH


    1. A003B6G

      Remove the clip.

    2. Detach the 5 claws and remove the cowl top ventilator louver LH.

  9. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY


    1. A003CR8

      Disconnect the connector. Then detach the clamp and remove the wire harness from the cowl top panel.

    2. A003ATE

      Remove the 2 bolts.

    3. A003ANA

      Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body and remove the wiper motor and link.