FRONT WIPER MOTOR REMOVAL

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WIPER ARM HEAD CAP


    1. A00OJK6

      Using a screwdriver, remove the front wiper arm head cap.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for all front wiper arm head caps.

  4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A00ONYS

      Remove the nut and the front wiper arm and blade assembly LH.

  5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A00OM49

      Remove the nut and the front wiper arm and blade assembly RH.

  6. REMOVE HOOD TO COWL TOP SEAL


    1. A00OKSF

      Using a clip remover, detach the 6 clips and 2 claws and remove the hood to cowl top seal.

  7. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A00OJHX

      Remove the clip.

    2. Detach the 8 claws and remove the cowl top ventilator louver RH.

  8. REMOVE COWL TOP VENTILATOR LOUVER LH


    1. A00ONZA

      Remove the clip.

    2. Detach the 5 claws and remove the cowl top ventilator louver LH.

  9. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY


    1. A00OIY3

      Disconnect the connector. Then detach the clamp and remove the wire harness from the cowl top panel.

    2. A00OIUJ

      Remove the 2 bolts.

    3. A00OKC9

      Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body and remove the wiper motor and link.