OUTER REAR VIEW MIRROR INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

    A005SV0

    1. Install the outer rear view mirror with the 3 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Attach the clamp.

    3. Connect the connector.

  2. INSTALL OUTER MIRROR INSTALL HOLE COVER LH


    1. A00OJWL

      Attach the 7 claws to install the outer mirror install hole cover.

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A00OJGZ

      for Manual Seat:

      Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

    2. for Power Seat:


      1. A00OK8Z

        Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

      2. Connect the connector.

      3. A00OJUH

        Attach the wire harness.

    3. A00OJX7

      Attach the front door trim board with the 5 claws of the front door inner glass weatherstrip.

    4. Connect the courtesy light connector.

    5. A00OM0V

      Attach the 2 claws and 10 clips to install the trim board.

    6. Install the 3 screws.

  4. INSTALL COURTESY LIGHT ASSEMBLY


    1. A005WA4

      Attach the 2 claws to install the light.

  5. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION


    1. Install the front door No. 1 stiffener cushion.

  6. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Tech Tips

    Use the same procedure described for the driver side.

  7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    A00OIICE01

    1. Connect the connector.

    2. Attach the 7 claws and clip to install the front armrest base panel.

  8. INSTALL ASSIST GRIP COVER LH


    1. A00OLJN

      Attach the 9 claws to install the assist grip cover.

  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A00OMIA

      Attach the 3 claws to install the inside handle bezel plug.