POWER WINDOW CONTROL SYSTEM Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH

DESCRIPTION



WIRING DIAGRAM

A006TSEE02

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Check for DTCs Click here.

      Result:
      Result Proceed to
      DTC is not output A
      B2311 is output B
      B2312 is output C
      B2313 is output D
      LIN communication system DTCs are output E

    B
    C
    D
    E
    A
  2. CHECK MANUAL UP/DOWN FUNCTION (REAR DOOR WINDOW REGULATOR SWITCH ASSEMBLY RH)


    1. Check that the manual up/down function using the rear power window regulator switch RH can operate the rear door power window RH Click here.

      OK
      Manual up/down function operates.

    NG
    OK
  3. READ VALUE USING INTELLIGENT TESTER (REAR DOOR WINDOW REGULATOR ASSEMBLY RH)


    1. Use the Data List to check if the power window regulator is functioning properly Click here.

      RR-Door Motor
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      RR Door P/W Auto SW Rear power window RH auto up/down signal / ON or OFF

      ON: Rear power window RH auto up/down switch operated

      OFF: Rear power window RH switch not operated

      -
      OK
      Display changes according to operation of rear power window switch RH.

    NG
    OK
  4. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH

    A006U4FE09
    Text in Illustration
    *1

    Component without harness connected

    (Rear Power Window Regulator Switch RH)


    1. Remove the rear power window regulator switch RH Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      8 (AUTO) - 1 (GND) Auto up/down operation Below 1 Ω

    NG
    OK
  5. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH - REAR DOOR WINDOW REGULATOR ASSEMBLY RH)

    A006VTIE06
    Text in Illustration
    *1

    Front view of wire harness connector

    (to Rear Power Window Regulator Switch RH)

    *2

    Front view of wire harness connector

    (to Rear Door Window Regulator RH)


    1. Disconnect the F1 switch connector.

    2. Disconnect the F4 regulator connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F1-8 (AUTO) - F4-4 (AUTO) Always Below 1 Ω
      F1-8 (AUTO) or F4-4 (AUTO) - Body ground Always 10 kΩ or higher

    NG
    OK