FRONT CONSOLE BOX (w/o Console Box Lid) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. A00DSVAE01
      Text in Illustration
      *1 Protective Tape
      *2 Clamp
      *3 Guide

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 2 clips and 5 claws.

    3. Detach the clamp.

    4. Detach the guide near the front of the vehicle and remove the finish panel.

  2. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A00DQADE01
      Text in Illustration
      *1 Protective Tape
      *2 Clamp
      *3 Guide

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 2 clips and 5 claws.

    3. Detach the clamp.

    4. Detach the guide near the front of the vehicle and remove the finish panel.

  3. REMOVE NO. 3 BOX PANEL


    1. A005V31E02
      Text in Illustration
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 6 clips and remove the box panel.

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


    1. Using a moulding remover B, detach the 4 clips and 5 claws and remove the panel end.

      A00DV3GE01

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


    1. A00DUWJ

      Using a moulding remover B, detach the 4 clips and 5 claws and remove the panel end.

  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A005TOC

      Twist the shift lever knob in the direction indicated by the arrow and remove it.

  7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A005VX2

      Detach the cover.

    2. A005V73

      Using a moulding remover B, detach the 2 claws.

    3. Detach the 6 clips and remove the console panel.

  8. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL


    1. A005TNN

      Using a moulding remover B, detach the 2 clips.

    2. A005V6ZE01
      Text in Illustration
      *1 w/ Seat Heater System

      Remove the finish panel and then disconnect the connectors.

  9. REMOVE CONSOLE BOX CARPET


    1. Remove the 3 carpets.

  10. REMOVE CONSOLE BOX ASSEMBLY


    1. w/ Power Outlet Socket:


      1. Disconnect the connectors.

    2. Remove the 2 screws.

    3. Remove the 4 bolts and console box.

      A005RJME01