COMPRESSOR (for ZR Series Engine) REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A00OIJQ

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OKW2

      Remove the 7 clips and radiator support opening cover.

  3. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Start the engine.

    2. Turn the A/C switch on.

    3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

    4. Stop the engine.

    5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  4. REMOVE FRONT LOWER BUMPER ABSORBER


    1. A00OL3A

      Remove the 4 screws and 2 bolt.

    2. A00OI9A

      Remove the 3 screws, 8 bolts and front lower bumper absorber.

  5. REMOVE NO. 1 ENGINE UNDER COVER


    1. A00ON3U

      Remove the 10 clips and under cover.

  6. REMOVE NO. 1 ENGINE UNDER COVER (for Rough Road Area Specification Vehicles)


    1. A00OL2M

      Remove the 3 clips and under cover.

  7. REMOVE REAR ENGINE UNDER COVER RH


    1. A00OMDF

      Remove the 5 clips and under cover RH.

  8. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A00OJKI

      Remove the 4 bolts and front suspension member reinforcement RH.

  9. REMOVE V-RIBBED BELT


    1. for 1ZR-FAE:

      Remove the V-ribbed belt Click here.

    2. for 2ZR-FAE:

      Remove the V-ribbed belt Click here.

    3. for 3ZR-FAE:

      Remove the V-ribbed belt Click here.

    4. for 3ZR-FE:

      Remove the V-ribbed belt Click here.

  10. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    1. A00ONS7

      Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with pulley.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

    2. Remove the O-ring from the discharge hose sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  11. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    1. A00OJTM

      Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

    2. Remove the O-ring from the suction hose sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  12. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY

    A00ONPK

    1. Detach the 2 clamps.

    2. Disconnect the connector.

    3. A00OJFT

      Remove the 2 bolts and 2 nuts.

    4. A00OO0Y

      Using a "TORX" socket wrench (E8), remove the 2 stud bolts and the compressor assembly with pulley.