REAR CENTER SEAT OUTER BELT ASSEMBLY (for Sedan) INSTALLATION


  1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY

    A003CXYE01

    1. Align the claw with the outer belt positioning hole.

    2. Install the outer belt with the bolt.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

  2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

    A00OMP2

    1. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    2. Attach the 5 claws and 2 clips to install the package tray trim panel assembly.

    3. Install the 4 clips.

  3. INSTALL REAR SEAT SHOULDER BELT HOLE COVER

    A00OIK4

    1. Attach the 4 claws to install the belt hole cover.

      Tech Tips

      Use the same procedure to install all the belt hole covers.

  4. INSTALL INNER ROOF SIDE GARNISH LH

    A00OLHOE01
    Text in Illustration
    *1 Clip A

    1. Install 2 new clips labeled A to the inner roof side garnish.

    2. Attach the 5 clips to install the inner roof side garnish.

  5. INSTALL INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    A003BSLE01
    Text in Illustration
    *1 Protruding Part

    1. Connect the center seat outer belt anchor with the bolt.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

      Note

      Do not allow the anchor part of the seat belt to overlap the protruding parts of the inner belt.

  7. INSTALL REAR SIDE SEATBACK ASSEMBLY LH


    1. A003BE1E01

      Install the claw as shown in the illustration.

    2. Install the side seatback with the bolt.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }
    3. A003CVN

      Install the rear seat 3 point type belt anchor with the bolt.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

      Note

      Do not allow the anchor part of the rear seat 3 point type belt to overlap the protruding parts of the floor panel.

    4. Install the seat belt to the belt guide.

    5. Attach the claw to close the cap of the rear seat shoulder belt guide.

    6. Check if the ELR locks.

      Note

      The check should be performed with the outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  8. INSTALL REAR SIDE SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  9. INSTALL REAR BENCH TYPE SEAT CUSHION ASSEMBLY

    A003CGQE01

    1. Attach the 2 rear hooks of the seat cushion to the seatback.

    2. Attach the 2 front hooks to install the seat cushion.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.