FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    A00DUH9

    1. Align the claw with the adjuster positioning hole and install the adjuster with the 2 bolts.

      Tech Tips

      First install the lower bolt, and then install the upper bolt.

      Torque:
      41 N*m  { 428 kgf*cm, 30 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

    Note


    • When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.

    • Align the seat belt positioning holes with the claws and install the retractor of the seat belt with the bolt as shown in the illustration.


    1. A00DRQJE01
      Text in Illustration
      *1 Bolt A
      *2 Bolt B

      Install the seat belt with the 2 bolts.

      Tech Tips

      First install bolt A, and then install bolt B.

      Torque:
      for bolt A
      5.0 N*m  { 51 kgf*cm, 30 in.*lbf }
      for bolt B
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }
    2. A00DS72

      Connect the pretensioner connector as shown in the illustration.

    3. A00DS9R

      Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

  3. INSTALL CENTER PILLAR GARNISH LH

    A00DQWW

    1. Pass the front seat outer belt floor anchor through the center pillar garnish.

    2. Attach the clip to install the center pillar garnish.

    3. Install the 2 screws.

    4. A00DSWD

      Install the front seat outer belt floor anchor with the bolt.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

  4. INSTALL LAP BELT OUTER ANCHOR COVER

    A00DQYD

    Tech Tips

    Use the same procedure for the other lap belt outer anchor cover.


    1. Attach the 3 claws to install the lap belt outer anchor cover.

  5. INSTALL LOWER CENTER PILLAR GARNISH LH

    A00DQF2

    1. Attach the 2 claws and 3 clips to install the lower center pillar garnish.

  6. INSTALL REAR DOOR SCUFF PLATE LH

    A00DTVS

    1. Attach the clip and 6 claws to install the front door scuff plate.

  7. INSTALL FRONT DOOR SCUFF PLATE LH

    A00DQKA

    1. Attach the 2 clips and 8 claws to install the front door scuff plate.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.