LUMBAR SWITCH (for Manual Seat) INSTALLATION

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL LUMBAR FRONT POWER SEAT SWITCH


    1. A003D12

      Install the 2 screws and switch.

  2. INSTALL FRONT SEAT CUSHION SHIELD LH


    1. A010I8D

      w/ Lumbar Support:

      Connect the connector.

    2. A010INS

      Attach the claw and hook to install the cushion shield.

    3. Install the 2 screws.

  3. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH


    1. A010KI5

      Attach the claw to install the release handle.

  4. INSTALL VERTICAL ADJUSTING HANDLE LH


    1. A010LKH

      Install the handle with the 2 screws.

  5. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP


    1. A010IM5

      Attach the 2 claws to install the cap.

  6. INSTALL FRONT SEAT ASSEMBLY


    1. Install the front seat assembly Click here.

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.

  8. INSPECT FRONT SEAT ASSEMBLY (w/ Seat Heater System)


    1. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch ON.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.