FRONT SEAT ASSEMBLY (for Manual Seat) INSTALLATION

Note

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT SEAT ASSEMBLY


    1. A003DXW

      Install the front seat assembly as shown in the illustration.

      Note


      • Be careful not to damage the vehicle body.

      • Make sure the seatback does not contact the shift lever knob.

      Tech Tips

      Install the seat assembly through the door frame so that it passes under the steering wheel.

    2. Connect the connectors under the seat.

    3. Temporarily install the front seat assembly with the 4 bolts.

    4. Lift up the seat track adjusting handle and move the seat to the foremost position.

    5. A003B3JE01

      Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    6. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    7. A003CVIE01

      Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER


    1. A003AJE

      Attach the 3 claws to install the cover.

  3. INSTALL FRONT SEAT INNER TRACK BRACKET COVER


    1. A003BW6

      Attach the 3 claws to install the cover.

  4. INSTALL FRONT SEAT REAR OUTER TRACK COVER


    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. A003EGR

      Attach the 2 claws to install the cover.

  5. INSTALL FRONT SEAT REAR INNER TRACK COVER


    1. A003DF5

      Attach the 2 claws to install the cover.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.

  8. INSPECT FRONT SEAT ASSEMBLY (w/ Seat Heater System)


    1. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch ON.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.