FRONT AIRBAG SENSOR INSTALLATION

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

INSTALL FRONT AIRBAG SENSOR LH
1. Check that the ignition switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  Note
  - w/ Navigation System for HDD:
    
    After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
  - When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
3. Connect the connector.
4. Install the front airbag sensor with the bolt.
  
  Torque:
  
  9.0 N*m { 92 kgf*cm, 80 in.*lbf }
  Note
  - If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
5. Check that the front airbag sensor is not loose.
INSTALL HEADLIGHT ASSEMBLY
1. for Halogen Headlight:
  1. Install the headlight Click here.
2. for HID Headlight:
  1. Install the headlight Click here.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL RADIATOR SUPPORT OPENING COVER
1. Install the radiator support opening cover with the 7 clips.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light Click here.