SPIRAL CABLE INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL SPIRAL CABLE SUB-ASSEMBLY


    1. A003EP4

      Attach the 3 claws and install the spiral cable.

      CAUTION:

      When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

    2. Connect the connectors to the spiral cable.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL UPPER STEERING COLUMN COVER


    1. for Power Tilt and Power Telescopic Steering Column:


      1. Install the upper steering column cover Click here.

    2. for Manual Tilt and Manual Telescopic Steering Column:


      1. Install the upper steering column cover Click here.

  3. INSTALL LOWER STEERING COLUMN COVER


    1. for Power Tilt and Power Telescopic Steering Column:


      1. Install the lower steering column cover Click here.

    2. for Manual Tilt and Manual Telescopic Steering Column:


      1. Install the lower steering column cover Click here.

  4. INSTALL LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

    A00OMND

    1. Attach the 4 claws to install the lower No. 2 steering column cover.

  5. ADJUST SPIRAL CABLE SUB-ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A003BHW

      Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

    4. A003E5M

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  6. INSTALL STEERING WHEEL ASSEMBLY


    1. Install the steering wheel assembly Click here.