DOOR COURTESY LIGHT INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL COURTESY LIGHT BULB


    1. A005VDO

      Install the bulb.

    2. Attach the 3 claws to install the cover.

  2. INSTALL COURTESY LIGHT ASSEMBLY


    1. A005WA4

      Attach the 2 claws to install the light.

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A003B1K

      for Manual Seat:

      Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

    2. for Power Seat:


      1. A003DIE

        Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

      2. Connect the connector.

      3. A003C9U

        Attach the wire harness.

    3. A003BXA

      Attach the front door trim board with the 5 claws of the front door inner glass weatherstrip.

    4. Connect the courtesy light connector.

    5. A003B48

      Attach the 2 claws and 10 clips to install the trim board.

    6. Install the 3 screws.

  4. INSTALL NO. 1 FRONT DOOR STIFFENER CUSHION


    1. Install the front door No. 1 stiffener cushion.

  5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A003DEV

      Attach the 2 claws to install the regulator switch.

  6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Driver Side)


    1. A003C42E01
      Text in Illustration
      *1 w/ Rear Door Power Window
      *2 w/o Rear Door Power Window

      w/ Rear Door Power Window:


      1. Attach the 4 claws to install the master switch assembly.

      2. Install the 3 screws.

    2. w/o Rear Door Power Window:


      1. Install the master switch assembly with the 3 screws.

  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. Tighten the screw using a T30 "TORX" socket to install the cover.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }
    2. A003E54

      Install the hole plug.

  8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    A003AO9E01

    1. Connect the connector.

    2. Attach the 7 claws and clip to install the front armrest base panel.

  9. INSTALL ASSIST GRIP COVER LH


    1. A003E1P

      Attach the 9 claws to install the assist grip cover.

  10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A003D69

      Attach the 3 claws to install the inside handle bezel plug.