CLEARANCE SONAR MAIN SWITCH (for RHD) REMOVAL


  1. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. A00DSVAE01
      Text in Illustration
      *1 Protective Tape
      *2 Clamp
      *3 Guide

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 2 clips and 5 claws.

    3. Detach the clamp.

    4. Detach the guide near the front of the vehicle and remove the finish panel.

  2. REMOVE NO. 3 BOX PANEL


    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 clips and remove the box panel.

      A005V11E01
      Text in Illustration
      *1 Protective Tape

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


    1. w/o TOYOTA Parking Assist-sensor System:


      1. Using a moulding remover B, detach the 4 clips and 5 claws and remove the panel end.

    2. w/ TOYOTA Parking Assist-sensor System:


      1. Using a moulding remover B, detach the 4 clips and 5 claws.

      2. Remove the panel end and then disconnect the connector.

        A00DPQSE01

  4. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY


    1. A005SBF

      Detach the 2 claws and remove the back sonar or clearance sonar switch.