INSTRUMENT PANEL SPEAKER (for 6 Speakers) INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY


    1. A00OSZ9

      Attach the 3 claws to install the front No. 2 speaker.

      Note

      Do not touch the cone part of the speaker.

  2. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. A00OV5M

      Connect the speaker connector.

    2. A00OVLC

      Set the 2 claws on the side of the speaker panel towards the front of the vehicle in place and using them as pivot points, lower the panel in the direction indicated by the arrow in the illustration, and then attach the claws and clips to the instrument panel to install the speaker panel.

  3. INSTALL FRONT PILLAR GARNISH LH (for Sedan)

    A010HAVE01
    Text in Illustration
    *1 Front Pillar Garnish Clip
    *2 Protective Tape

    1. w/ Curtain Shield Airbag:

      Remove the protective cover.

    2. Attach the 2 guides.

    3. Turn the end of the front pillar garnish clip 90° with needle-nose pliers and install it to the front pillar garnish.

      Tech Tips

      Tape the tips of the needle-nose pliers before use.

    4. A010K6FE01
      Text in Illustration
      *1 Front Pillar Garnish Clip

      Attach the 2 clips to install the front pillar garnish.

  4. INSTALL FRONT PILLAR GARNISH LH (for Wagon)

    A010HAVE01
    Text in Illustration
    *1 Front Pillar Garnish Clip
    *2 Protective Tape

    1. Remove the protective cover.

    2. Attach the 2 guides.

    3. Turn the end of the front pillar garnish clip 90° with needle-nose pliers and install it to the front pillar garnish.

      Tech Tips

      Tape the tips of the needle-nose pliers before use.

    4. A010K6FE01
      Text in Illustration
      *1 Front Pillar Garnish Clip

      Attach the 2 clips to install the front pillar garnish.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.