REAR DOOR SPEAKER REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    1. A010LNI

      Insert clip remover between the plate and trim board.

    2. Turn the handle counterclockwise to remove the snap ring and handle.

  4. REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)


    1. Remove the inside handle plate.

  5. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A010HOS

      Using moulding remover A, detach the 3 claws and remove the bezel plug.

  6. REMOVE DOOR ASSIST GRIP COVER LH


    1. A010HM7

      Using moulding remover A, detach the 10 claws and remove the assist grip cover.

  7. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A010K1N

      Using moulding remover A, detach the 6 claws and the clip.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A010K0H

      Remove the 3 screws.

    2. Using a clip remover, detach the 8 clips.

    3. A010J2PE01
      Text in Illustration
      *1 w/ Rear Door Sunshade
      *2 w/o Rear Door Sunshade

      Pull out the rear door trim board in the direction indicated by the arrow.

    4. for 11 Speakers:


      1. Disconnect the connector.

    5. A010HB4

      Disconnect the 2 cables from the inside handle.

  9. REMOVE REAR NO. 1 SPEAKER ASSEMBLY


    1. Disconnect the speaker connector.

    2. A00OT1D

      Using a drill bit with a diameter of less than 4 mm (0.157 in.), drill out the 3 rivet heads.

      CAUTION:

      Be careful as the cut rivet will be very hot.

      Note

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

      Note

      Do not touch the cone part of the speaker.

    5. Detach the claw and remove the speaker.

  10. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 11 Speakers)


    1. A00ORKJ

      Detach the clamp.

    2. Remove the 2 screws and speaker.

      Note

      Do not touch the cone part of the speaker.