FRONT DOOR SPEAKER INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


    1. A003AS7E01

      Temporarily install the speaker by attaching the claw of the speaker to the door panel.

    2. Install the speaker with the 4 screws in the order shown in the illustration.

    3. Connect the speaker connector.

      Note

      Do not touch the cone part of the speaker.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A00OJGZ

      for Manual Seat:

      Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

    2. for Power Seat:


      1. A00OK8Z

        Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

      2. Connect the connector.

      3. A00OJUH

        Attach the wire harness.

    3. A00OJX7

      Attach the front door trim board with the 5 claws of the front door inner glass weatherstrip.

    4. Connect the courtesy light connector.

    5. A00OM0V

      Attach the 2 claws and 10 clips to install the trim board.

    6. Install the 3 screws.

  3. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Tech Tips

    Use the same procedure described for the driver side.

  4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    A00OIICE01

    1. Connect the connector.

    2. Attach the 7 claws and clip to install the front armrest base panel.

  5. INSTALL ASSIST GRIP COVER LH


    1. A00OLJN

      Attach the 9 claws to install the assist grip cover.

  6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A00OMIA

      Attach the 3 claws to install the inside handle bezel plug.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL ENGINE ROOM SIDE COVER


    1. A00OKW2

      Install the radiator support opening cover with the 7 clips.