AUDIO AND VISUAL SYSTEM Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly or radio receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly, or speakers.

WIRING DIAGRAM

A003EP0E01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)


    1. A003EMZE01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Radio Receiver Assembly)
      *2

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Disconnect the D15 radio receiver connector.

    2. Disconnect the D38 stereo jack adapter connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D15-17 (ALI) - D38-1 (ALO) Always Below 1 Ω
      D15-15 (ARI) - D38-2 (ARO)
      D15-16 (ASGN) - D38-3 (ASGN)
      D15-18 (AGND) - D38-5 (AGND)
      D15-19 (AUXI) - D38-4 (AUXO)
      D15-17 (ALI) - Body ground Always 10 kΩ or higher
      D15-15 (ARI) - Body ground
      D15-16 (ASGN) - Body ground
      D15-19 (AUXI) - Body ground

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here