REAR AXLE HUB INSTALLATION


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH


    1. A005WL5

      Install the rear axle hub and bearing assembly with 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

  2. CONNECT SKID CONTROL SENSOR WIRE


    1. A005W3S

      Connect the skid control sensor wire connector to the skid control sensor.

      Note

      Do not twist the sensor wire when installing the clamp.

  3. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A005RYI

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum looseness
      0.05 mm (0.00197 in.)

      Note

      Make sure Ensure that the dial indicator is set perpendicular to the measurement surface.

      Tech Tips

      If the looseness more than the maximum, replace the axle hub assembly.

  4. INSPECT REAR AXLE HUB RUNOUT


    1. A005UPY

      Using a dial indicator, check for runout on the surface of the axle hub inside the rear axle hub bolts.

      Maximum runout
      0.08 mm (0.00314 in.)

      Note


      • Make sure that the dial indicator is set perpendicular to the measurement surface.

      • Make sure to set the tip of the dial indicator inside the rear axle hub bolt.

      If the runout more than the maximum, replace the rear axle hub and bearing assembly.

  5. INSTALL REAR DISC


    1. A00ONLDE01
      Text in Illustration
      *1 Matchmark

      Align the matchmarks of the disc and axle hub and install the disc.

      Note

      When replacing the disc with a new one, select the installation position where the rear disc has minimal runout.

  6. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. Install the rear disc brake cylinder assembly Click here.

  7. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  8. INSPECT REAR WHEEL ALIGNMENT


    1. Inspect the rear wheel alignment Click here.

  9. CHECK SPEED SENSOR SIGNAL


    1. Inspect the speed sensor signal Click here.