SHIFT PADDLE SWITCH INSTALLATION


  1. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY

    A010KN0E02

    1. Install the 2 shift switches and 2 brackets with the 4 screws.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }
      Text in Illustration
      *1 Shift Switch
      *2 Bracket

      Note

      Make sure that the brackets are securely installed.

    2. A010G42E02
      Text in Illustration
      *1 Switch Wire

      Connect the 2 switch wire connectors to the shift switches.

    3. A010G3H

      Connect the connector to the steering wheel.

    4. Attach the clamp to the steering wheel.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. ADJUST SPIRAL CABLE


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A003BHW

      Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

    4. A003E5M

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  4. INSTALL STEERING WHEEL ASSEMBLY


    1. A003C9PE01
      Text in Illustration
      *1 Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect the connectors to the spiral cable sub-assembly.

  5. INSTALL STEERING PAD


    1. A00OTCW

      Support the steering pad with one hand.

    2. Connect the connector to the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Attach the 2 springs to install the steering pad.

  6. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A00OUQ6

      Attach the 2 claws to install the steering wheel cover.

  7. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A00ORDTE01
      Text in Illustration
      *1 w/o Cruise Control System
      *2 w/ Cruise Control System

      Attach the 2 claws to install the steering wheel cover.

  8. INSPECT STEERING WHEEL CENTER POINT

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. CLEAN SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.