SHIFT PADDLE SWITCH REMOVAL

CAUTION:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing Click here.


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A00OUQ6

      Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A00ORDTE01
      Text in Illustration
      *1 w/o Cruise Control System
      *2 w/ Cruise Control System

      Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE STEERING PAD


    1. A00OVRM

      Using a screwdriver, detach the 2 springs and remove the steering pad.

    2. A00OTCW

      Pull out the steering pad from the steering wheel as shown in the illustration and support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  6. REMOVE STEERING WHEEL ASSEMBLY


    1. A00DSQVE01
      Text in Illustration
      *1 Matchmark

      Remove the steering wheel assembly set nut.

    2. Put matchmarks on the steering wheel assembly and steering main shaft.

    3. Disconnect the connectors from the spiral cable.

    4. A00DRJ5E01
      Text in Illustration
      *1 Turn
      *2 Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  7. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY

    A010G3H

    1. Detach the clamp from the steering wheel.

    2. Disconnect the switch wire connector from the steering wheel.

    3. A010G42E02
      Text in Illustration
      *1 Switch Wire

      Disconnect the 2 connectors from the 2 shift switches, and remove the switch wire.

    4. A010KN0E02
      Text in Illustration
      *1 Shift Switch
      *2 Bracket

      Remove the 4 screws, 2 brackets and 2 shift switches.