TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A005W8Q

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE AIR CLEANER CAP AND HOSE


    1. A005SHE

      Disconnect the mass air flow meter connector.

    2. Detach the wire harness from the 2 clamps.

    3. A005UHW

      Disconnect the 2 clamps.

    4. A005SIR

      Disconnect the ventilation hose.

    5. Loosen the band and remove the air cleaner cap.

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A00DQ1D

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  4. REMOVE NO. 2 ENGINE UNDER COVER


    1. A00OLHN

      Remove the 4 clips and under cover.

  5. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Detach the clamp and disconnect the heated oxygen sensor wire harness.

    2. Disconnect the heated oxygen sensor connector.

    3. A00DTVW

      Remove the 2 bolts and 2 compression springs.

    4. A00DRN8

      Remove the 2 bolts and 2 compression springs.

    5. Remove the 2 exhaust pipe supports and front exhaust pipe assembly.

  7. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

    A005T3E

    1. Remove the 5 nuts and heat insulator.

  8. REMOVE CONSOLE BOX ASSEMBLY


    1. Remove the console box assembly Click here

  9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A005V6LE01

      Disconnect the end of the transmission control cable from the shift lever.

    3. A005T1IE01
      Text in Illustration
      *1 Stopper
      *2 Nut

      Pull out the stopper of the transmission control cable.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    5. A005T1C

      Remove the nut and disconnect the control cable from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable from the control cable bracket.

    7. A005RER

      Remove the bolt and disconnect the transmission control cable support.

    8. A005WIV

      Remove the 2 nuts and disconnect the transmission control cable assembly.

    9. Pull out the transmission control cable assembly to remove it.