PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A005W8Q

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE AIR CLEANER CAP AND HOSE


    1. A005SHE

      Disconnect the mass air flow meter connector.

    2. Detach the wire harness from the 2 clamps.

    3. A005UHW

      Disconnect the 2 clamps.

    4. A005SIR

      Disconnect the ventilation hose.

    5. Loosen the band and remove the air cleaner cap.

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A00DQ1D

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  4. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A005SUY

      Remove the nut and disconnect the control cable assembly from the control shaft lever.

  5. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    A005TR8

    1. Remove the nut, washer and control shaft lever.

    2. Disconnect the park/neutral position switch connector.

    3. A005TW5E01

      Using a screwdriver, bend the tabs of the lock plate.

    4. Remove the lock nut and lock plate.

      Text in Illustration
      *1 Lock Plate
    5. A005UK1

      Remove the 2 bolts and pull out the park/neutral position switch assembly to remove it.