REVOLUTION SENSOR INSTALLATION


  1. INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)

    A00OIM2

    1. Coat a new O-ring with Toyota Genuine CVT fluid TC and install it to the transmission revolution sensor.

    2. Install the transmission revolution sensor with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Connect the transmission revolution sensor connector.

  2. INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)

    A00ONFD

    1. Coat a new O-ring with Toyota Genuine CVT fluid TC and install it to the transmission revolution sensor.

    2. Install the transmission revolution sensor with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Connect the transmission revolution sensor connector.

  3. INSTALL TRANSMISSION REVOLUTION SENSOR (NT)

    A00OJJD

    1. Coat a new O-ring with Toyota Genuine CVT fluid TC and install it to the transmission revolution sensor.

    2. Install the transmission revolution sensor with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Connect the transmission revolution sensor connector.

  4. INSTALL REAR ENGINE UNDER COVER LH


    1. Install the under cover LH with the 5 clips.

  5. INSTALL NO. 1 ENGINE UNDER COVER


    1. A00ON3U

      Install the under cover with the 10 clips.

  6. INSTALL FRONT LOWER BUMPER ABSORBER


    1. A00OI9A

      Install the front lower bumper absorber with the 3 screws and 8 bolts.

    2. A00OL3A

      Install the 4 screws and 2 bolts.

  7. INSTALL BATTERY CARRIER


    1. A00OKIS

      Install the battery carrier with the 4 bolts.

      Torque:
      19 N*m  { 189 kgf*cm, 14 ft.*lbf }
    2. A00OHVH

      Install the radiator pipe with the 2 bolts.

      Torque:
      19 N*m  { 189 kgf*cm, 14 ft.*lbf }

    3. Connect the 2 wire harness clamps.

  8. INSTALL BATTERY


    1. Install the battery tray.

    2. Install the battery.

    3. Install the battery clamp with the bolt and tighten the nut.

      Torque:
      for bolt
      17 N*m  { 168 kgf*cm, 12 ft.*lbf }
      for nut
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

    4. Connect the cable to the positive (+) battery terminal.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL RADIATOR SUPPORT OPENING COVER


    1. A00OKW2

      Install the radiator support opening cover with the 7 clips.