REVOLUTION SENSOR REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OKW2

      Remove the 7 clips and radiator support opening cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BATTERY


    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  4. REMOVE BATTERY CARRIER


    1. A00OHVH

      Disconnect the 2 wire harness clamps from the battery carrier.

    2. Remove the 2 bolts and disconnect the radiator pipe from the battery carrier.

    3. A00OKIS

      Remove the 4 bolts and battery carrier.

  5. REMOVE FRONT LOWER BUMPER ABSORBER


    1. A00OL3A

      Remove the 4 screws and 2 bolts.

    2. A00OI9A

      Remove the 3 screws, 8 bolts and front lower bumper absorber.

  6. REMOVE NO. 1 ENGINE UNDER COVER


    1. A00ON3U

      Remove the 10 clips and under cover.

  7. REMOVE REAR ENGINE UNDER COVER LH


    1. Remove the 5 clips and under cover.

  8. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

    A00OJJD

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  9. REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

    A00ONFD

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  10. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

    A00OIM2

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.