OIL COOLER REMOVAL

REMOVE RADIATOR SUPPORT OPENING COVER
1. Remove the 7 clips and radiator support opening cover.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
- w/ Navigation System (for HDD):
  
  After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE BATTERY
1. Disconnect the cable from the positive (+) battery terminal.
2. Remove the bolt and loosen the nut.
3. Remove the battery clamp.
4. Remove the battery.
5. Remove the battery tray.
REMOVE BATTERY CARRIER
1. Disconnect the 2 wire harness clamps from the battery carrier.
2. Remove the 2 bolts and disconnect the radiator pipe from the battery carrier.
3. Remove the 4 bolts and battery carrier.
REMOVE FRONT LOWER BUMPER ABSORBER
1. Remove the 4 screws and 2 bolts.
2. Remove the 3 screws, 8 bolts and front lower bumper absorber.
REMOVE NO. 1 ENGINE UNDER COVER
1. Remove the 10 clips and under cover.
REMOVE REAR ENGINE UNDER COVER LH
1. Remove the 5 clips and under cover.
DRAIN ENGINE COOLANT
1. Loosen the radiator drain cock plug.
  
  Tech Tips
  
  Collect the coolant in a container and dispose of it according to the regulations in your area.
2. Remove the reserve tank cap.
  
  CAUTION:
  
  Do not remove the reserve tank cap while the engine and radiator are still hot.
  
  Pressurized, hot engine coolant and steam may be released and cause serious burns.
  
  Text in Illustration
  
  *1 Reserve Tank Cap *2 Radiator Drain Cock Plug
REMOVE TRANSMISSION OIL COOLER ASSEMBLY
1. Disconnect the 2 water by-pass hoses from the transmission oil cooler.
2. Remove the 3 bolts, transmission oil cooler and 2 O-rings from the continuously variable transaxle.