REVOLUTION SENSOR REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A005W8Q

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE AIR CLEANER CAP AND HOSE


    1. A005SHE

      Disconnect the mass air flow meter connector.

    2. Detach the wire harness from the 2 clamps.

    3. A005UHW

      Disconnect the 2 clamps.

    4. A005SIR

      Disconnect the ventilation hose.

    5. Loosen the band and remove the air cleaner cap.

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A00DQ1D

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  4. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

    A005RRL

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  5. REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

    A005RES

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  6. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

    A005SEC

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

    4. Lower the vehicle.