SHIFT LEVER ASSEMBLY INSTALLATION

INSTALL FLOOR SHIFT LEVER ASSEMBLY

Attach the 2 claws to connect the shift control cable and select control cable to the shift lever assembly.
Connect the end of the shift control cable to the shift lever assembly and install the clip.
Install the shift lever assembly with the 4 bolts.

Torque:

12 N*m { 122 kgf*cm, 9 ft.*lbf }
Attach the 3 wire harness clamps.
Release the lock of the cable length adjustment structure of the select cable.
1. Twist the stopper.
2. Pull the lock piece outward from the case to release the lock.

Text in Illustration
*1	Reverse Restrict Pin Assembly
*2	Outer Lever

Hook the outer lever of the manual transaxle onto the reverse restrict pin assembly to secure it.

Connect the end of the select control cable to the shift lever assembly and install the clip.
Note
- Make sure the lock piece of the select control cable is facing upward when the select control cable is connected.
- Make sure the clip is inserted in the direction shown in the illustration.
Text in Illustration

*1 Slider

*2 Inhibitor Wall

Push the slider against the inhibitor wall.
Note
- Do not pull up the slider.
- When adjusting the cable, make sure that the shift lever is not in 1 or 2.
Lock the cable length adjustment structure of the select cable.
1. Push the lock piece into the case with slider held against the inhibitor wall.
2. Return the stopper to prevent the lock from being released.
  Note
  
  Push in the lock piece completely.
  
  Make sure that the cable length adjustment structure is locked securely.
Move the shift lever to R to release the outer lever.

Text in Illustration
*1	Slider
*2	Inhibitor Wall