SHIFT LEVER ASSEMBLY INSTALLATION


  1. INSTALL FLOOR SHIFT LEVER ASSEMBLY


    1. A019B6F

      Attach the 2 claws to connect the shift control cable and select control cable to the shift lever assembly.

    2. A019AK7

      Connect the end of the shift control cable to the shift lever assembly and install the clip.

    3. A019DDE

      Install the shift lever assembly with the 4 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
    4. A019AC3

      Attach the 3 wire harness clamps.

    5. Release the lock of the cable length adjustment structure of the select cable.


      1. A019DA2E01

        Twist the stopper.

      2. A019CM0E01

        Pull the lock piece outward from the case to release the lock.

    6. A019DS9E01
      Text in Illustration
      *1 Select Outer Lever
      *2 Hole

      Align the hole of the select outer lever with the hole in the transmission.

    7. A01994D

      Insert a bolt into the aligned holes to fix the select outer lever in place.

      Note

      Do not push in the bolt forcefully or damage the transaxle case.

      Tech Tips


      • Use a bolt with a diameter of 6 mm (0.236 in.) and a length of at least 16 mm (0.630 in.).

      • Depending on the bolt diameter, it may be difficult to insert the bolt. In that case, use a bolt with a diameter smaller than 6 mm (0.236 in.).

    8. A0199TY

      Connect the end of the select control cable to the shift lever assembly and install the clip.

      Note


      • Make sure the lock piece of the select control cable is facing face upward when the select control cable is connected.

      • Make sure the clip is inserted in the direction shown in the illustration.

    9. A019BP5E01
      Text in Illustration
      *1 Slider
      *2 Inhibitor Wall

      Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    10. Lock the cable length adjustment structure of the select cable.


      1. A019B0PE01

        Push the lock piece into the case with the slider held against the inhibitor wall.

      2. A019C8GE01

        Return the stopper to prevent the lock from being released.

        Note


        • Push in the lock piece completely.

        • Make sure that the cable length adjustment structure is locked securely.

    11. A0199TD

      Remove the bolt to free the select outer lever.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here