TRANSMISSION CONTROL CABLE ADJUSTMENT


  1. ADJUST TRANSMISSION CONTROL SELECT CABLE

    Tech Tips


    • After the shift lever or the shift cable is replaced, be sure to adjust the transmission control cable assembly.

    • If the shift lever does not move (or the shift lever is difficult to move) to 1st or 2nd or if it is possible to move the shift lever to reverse without pulling up the slider shaft, the length of the cable must be adjusted.


    1. Disconnect the select control cable from the shift lever assembly.

    2. Release the lock of the cable length adjustment structure of the select cable.


      1. A005U3EE01

        Twist the stopper.

      2. A005UV4E01

        Pull the lock piece outward from the case to release the lock.

    3. A005TEGE01
      Text in Illustration
      *1 Select Outer Lever
      *2 Hole

      Align the hole of the select outer lever with the hole in the transaxle case.

    4. A005S9P

      Insert a bolt into the aligned holes to fix the select outer lever in place.

      Note

      Do not push in the bolt forcefully or damage the transaxle case.

      Tech Tips


      • Use a bolt with a diameter of 6 mm (0.236 in.) and a length of at least 16 mm (0.630 in.).

      • Depending on the bolt diameter, it may be difficult to insert the bolt. In that case, use a bolt with a diameter smaller than 6 mm (0.236 in.).

    5. Install the control select cable to the shift lever assembly.

    6. A005VIGE01
      Text in Illustration
      *1 Slider
      *2 Inhibitor Wall

      Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    7. Lock the cable length adjustment structure of the select cable.


      1. A005U24E01

        Push the lock piece into the case with the slider held against the inhibitor wall.

      2. A005VX3E01

        Return the stopper to prevent the lock from being released.

        Note


        • Push in the lock piece completely.

        • Make sure that the cable length adjustment structure is locked securely.

    8. A005RE8

      Remove the bolt to free the select outer lever.