TRANSMISSION CONTROL CABLE ADJUSTMENT


  1. ADJUST TRANSMISSION CONTROL SELECT CABLE

    Tech Tips


    • After the shift lever or the shift cable is replaced, be sure to adjust the transmission control cable assembly.

    • If the shift lever does not move (or the shift lever is difficult to move) to 1st or 2nd or if it is possible to move the shift lever to reverse without pulling up the slider shaft, the length of the cable must be adjusted.


    1. Disconnect the select control cable from the shift lever assembly.

    2. Release the lock of the cable length adjustment structure of the select cable.


      1. A005U3EE01

        Twist the stopper.

      2. A005UV4E01

        Pull the lock piece outward from the case to release the lock.

    3. A005VNXE01
      Text in Illustration
      *1 Reverse Restrict Pin Assembly
      *2 Outer Lever

      Hook the outer lever of the manual transaxle onto the reverse restrict pin assembly to secure it.

    4. Install the select control cable to the shift lever assembly.

    5. A005VIGE01
      Text in Illustration
      *1 Slider
      *2 Inhibitor Wall

      Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    6. Lock the cable length adjustment structure of the select cable.


      1. A005U24E01

        Push the lock piece into the case with the slider held against the inhibitor wall.

      2. A005VX3E01

        Return the stopper to prevent the lock from being released.

        Note


        • Push in the lock piece completely.

        • Make sure that the cable length adjustment structure is locked securely.

    7. A005U9IE01

      Move the shift lever to R to release the outer lever.