MANUAL TRANSAXLE OIL REPLACEMENT


  1. REMOVE ENGINE UNDER COVER


    1. A010GBF

      except Rough Road Area Specification Vehicles:

      Remove the 8 clips and fold back the engine under cover.

      Tech Tips

      It is not necessary to fully remove the engine under cover. Partially remove it so that the oil can be replaced in a later step.

  2. REMOVE FRONT LOWER BUMPER ABSORBER (for Rough Road Area Specification Vehicles)


    1. A00OL3A

      Remove the 4 screws and 2 bolts.

    2. A00OI9A

      Remove the 3 screws, 8 bolts and front lower bumper absorber.

  3. REMOVE NO. 1 ENGINE UNDER COVER (for Rough Road Area Specification Vehicles)


    1. A00OL2M

      Remove the 3 clips and under cover.

  4. DRAIN MANUAL TRANSAXLE OIL


    1. A010J8HE02
      Text in Illustration
      *1 Filler Plug
      *2 Drain Plug

      Remove the filler plug and gasket.

    2. Remove the drain plug and gasket to drain the manual transaxle oil.

    3. Install a new gasket and the drain plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

  5. ADD MANUAL TRANSAXLE OIL


    1. A010I5YE41

      Add oil until the oil level is within 5 mm (0.197 in.) from the bottom of the transmission filler plug opening.

      Manual Transaxle Gear Oil
      TOYOTA Genuine Manual Transmission Gear Oil LV or equivalent
      Oil Classification
      API GL-4 and SAE 75W
      Capacity
      2.4 liters (2.5 US qts, 2.1 IMP. qts)

    2. Install a new gasket and the transmission filler plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Note


      • When adding transaxle oil, make sure the vehicle is level.

      • An excessively large or small amount of oil may cause problems.

      • After adding oil, drive the vehicle and recheck the oil level.

  6. INSPECT FOR OIL LEAK

  7. INSTALL NO. 1 ENGINE UNDER COVER (for Rough Road Area Specification Vehicles)


    1. A00OL2M

      Install the under cover with the 3 clips.

  8. INSTALL FRONT LOWER BUMPER ABSORBER (for Rough Road Area Specification Vehicles)


    1. A00OI9A

      Install the front lower bumper absorber with the 3 screws and 8 bolts.

    2. A00OL3A

      Install the 4 screws and 2 bolts.

  9. INSTALL ENGINE UNDER COVER

    A010HF4

    1. except Rough Road Area Specification Vehicles:

      Install the engine under cover with the 8 clips.