PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OKW2

      Remove the 7 clips and radiator support opening cover.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY


    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  5. REMOVE BATTERY CARRIER

    A00OJKB

    1. Detach the 2 wire harness clamps.

    2. Remove the 4 bolts and battery carrier.

  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    A00OND7

    1. Remove the nut and disconnect the control cable from the control shaft lever.

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    A00OJCB

    1. Disconnect the park/neutral position switch connector.

    2. A00OLA0

      Remove the nut, washer and control shaft lever.

    3. A00OKEL

      Using a screwdriver, bend the tabs of the lock plate.

    4. Remove the lock nut and lock plate.

    5. A00OHZT

      Remove the 2 bolts and pull out the park/neutral position switch to remove it.