SPEED SENSOR INSTALLATION

INSTALL SPEED SENSOR NC
1. Coat a new O-ring with ATF WS.
2. Install the O-ring to the sensor.
3. Install the sensor with the bolt.
  
  Torque:
  
  8.8 N*m { 90 kgf*cm, 78 in.*lbf }
4. Connect the sensor connector.
INSTALL SPEED SENSOR NT
1. Coat a new O-ring with ATF WS.
2. Install the O-ring to the sensor.
3. Install the sensor with the bolt.
  
  Torque:
  
  8.8 N*m { 90 kgf*cm, 78 in.*lbf }
4. Connect the sensor connector.
INSTALL AIR CLEANER CASE SUB-ASSEMBLY
1. Install the air cleaner case with the 3 bolts.
  
  Torque:
  
  7.0 N*m { 71 kgf*cm, 62 in.*lbf }
2. Attach the wire harness clamp to the air cleaner case.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY
1. Connect the air cleaner cap with the band.
2. Connect the ventilation hose.
3. Connect the 2 clamps.
4. Attach the wire harness to the 2 clamps.
5. Connect the mass air flow meter connector.
INSTALL BATTERY CARRIER
1. Install the battery carrier with the 4 bolts.
  
  Torque:
  
  19 N*m { 194 kgf*cm, 14 ft.*lbf }
2. Attach the 2 wire harness clamps.
INSTALL BATTERY
1. Install the battery tray.
2. Install the battery.
3. Install the battery clamp with the bolt and tighten the nut.
  
  Torque:
  
  for bolt
  
  17 N*m { 168 kgf*cm, 12 ft.*lbf }
  
  for nut
  
  3.5 N*m { 36 kgf*cm, 31 in.*lbf }
4. Connect the cable to the positive (+) battery terminal.
  
  Torque:
  
  5.4 N*m { 55 kgf*cm, 48 in.*lbf }
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL NO. 2 CYLINDER HEAD COVER
1. Attach the 4 clips to install the cover.
  Note
  
  Be sure to attach the clips securely.
  
  Do not apply excessive force or hit the cover to attach the clips. This may cause the cover to break.
INSTALL RADIATOR SUPPORT OPENING COVER
1. Install the radiator support opening cover with the 7 clips.