WATER PUMP REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A00OKW2

      Remove the 7 clips and radiator support opening cover.

  2. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A00OIJQ

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  3. REMOVE REAR ENGINE UNDER COVER RH


    1. A00OMDF

      Remove the 5 clips and under cover RH.

  4. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the reserve tank cap.

      CAUTION:

      Do not remove the reserve tank cap while the engine and radiator are still hot.

      Pressurized, hot engine coolant and steam may be released and cause serious burns.

      A00DSEWE01
      Text in Illustration
      *1 Reserve Tank Cap *2 Radiator Drain Cock Plug

  7. REMOVE V-RIBBED BELT


    1. A00OILIE01

      Loosen bolts A and B.

    2. Loosen bolt C and remove the V-ribbed belt.

      Note

      Do not loosen bolt D.

  8. REMOVE GENERATOR ASSEMBLY


    1. A00ONWT

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the connector and detach the wire harness clamp.

    4. A00OK6FE01

      Remove the 2 bolts and adjusting bar.

    5. A00OKGNE01

      Remove the bolt and generator.

    6. A00OJ9U

      Remove the bolt and wire harness clamp bracket.

  9. REMOVE ENGINE WATER PUMP ASSEMBLY


    1. A00OI59

      Remove the 5 bolts and engine water pump from the timing chain cover.

    2. A00OL67E01

      Remove the gasket from the timing chain cover.