EXHAUST PIPE INSTALLATION


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A00DU2VE01

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum free length
      41.5 mm (1.63 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. A00DUDME11
      Text in Illustration
      *1 Gasket
      *2 Wooden Block

      Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the exhaust pipe, do not push in the gasket with the exhaust pipe.

    3. A00DRN8

      Install the 2 exhaust pipe supports, and then install the front exhaust pipe assembly with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 439 kgf*cm, 32 ft.*lbf }

  2. INSTALL HEATED OXYGEN SENSOR


    1. A00DTKPE01

      Using SST, install the heated oxygen sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips

      Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      Note

      Do not damage the sensor.

    2. A00DUJ9

      Install the wire harness clamp bracket.

    3. Attach the clamp.

    4. Connect the sensor connector.

  3. INSTALL NO. 2 ENGINE UNDER COVER


    1. A00DUSP

      Install the under cover with the 4 clips.

  4. INSTALL FRONT CENTER FLOOR BRACE

    A00DQAY

    1. Install the floor brace with the 4 bolts.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }

  5. INSTALL TAILPIPE ASSEMBLY


    1. A00DU2VE01

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum free length
      38.5 mm (1.52 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. A00DUDME11
      Text in Illustration
      *1 Gasket
      *2 Wooden Block

      Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the front exhaust pipe assembly.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the exhaust pipe, do not push in the gasket with the exhaust pipe.

    3. A00DTVW

      Install the 4 exhaust pipe supports, and then install the tailpipe assembly with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 439 kgf*cm, 32 ft.*lbf }

  6. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.