EXHAUST MANIFOLD REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A005W8Q

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    1. Remove the windshield wiper motor and link Click here.

  3. REMOVE OUTER COWL TOP PANEL


    1. A00DSK0

      Remove the 9 bolts and outer cowl top panel.

  4. REMOVE AIR FUEL RATIO SENSOR


    1. A00DQ8P

      Disconnect the sensor connector and clamp.

    2. A00DUZAE01

      Using SST, remove the sensor from the exhaust manifold.

      SST
      09224-00010

      Note

      Do not damage the ratio sensor.

  5. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A00DS4S

      Remove the bolt and bracket.

  6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A00DSGW

      Remove the 4 bolts and heat insulator.

  7. REMOVE NO. 2 ENGINE UNDER COVER


    1. A00DUSP

      Using a clip remover, remove the 4 clips and under cover.

  8. REMOVE FRONT CENTER FLOOR BRACE

    A00DQAY

    1. Remove the 4 bolts and floor brace.

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Detach the clamp and disconnect the heated oxygen sensor wire harness.

    2. Disconnect the heated oxygen sensor connector.

    3. A00DTVW

      Remove the 2 bolts and 2 compression springs.

    4. A00DRN8

      Remove the 2 bolts and 2 compression springs.

    5. Remove the 2 exhaust pipe supports and front exhaust pipe assembly.

  10. REMOVE DRIVE SHAFT HEAT INSULATOR SUB-ASSEMBLY


    1. A00DRNI

      Remove the 2 nuts and heat insulator.

  11. REMOVE MANIFOLD STAY


    1. A00DRR8

      Remove the 3 bolts and manifold stay.

  12. REMOVE EXHAUST MANIFOLD


    1. A00DTLY

      Remove the 5 nuts and exhaust manifold.

    2. Remove the exhaust manifold gasket.

  13. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    1. A00DQN9

      Remove the 3 bolts and heat insulator.