EXHAUST PIPE REMOVAL


  1. REMOVE TAILPIPE ASSEMBLY


    1. A00DTVW

      Remove the 2 bolts and 2 compression springs.

    2. Remove the 4 exhaust pipe supports and tailpipe assembly.

  2. REMOVE FRONT CENTER FLOOR BRACE


    1. A00DQAY

      Remove the 4 bolts and floor brace.

  3. REMOVE NO. 2 ENGINE UNDER COVER


    1. A00DUSP

      Using a clip remover, remove the 4 clips and under cover.

  4. REMOVE HEATED OXYGEN SENSOR


    1. A00DTKPE01

      Using SST, install the heated oxygen sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips

      Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      Note

      Do not damage the sensor.

    2. A00DUJ9

      Install the wire harness clamp bracket.

    3. Attach the clamp.

    4. Connect the sensor connector.

  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. A00DRN8

      Remove the 2 bolts and 2 compression springs.

    2. Remove the 2 exhaust pipe supports and front exhaust pipe assembly.