FUEL INJECTOR REMOVAL


  1. DISCHARGE FUEL SYSTEM PRESSURE


    1. Discharge fuel system pressure Click here.

  2. REMOVE ENGINE ROOM SIDE COVER


    1. A00DSOB

      Remove the clip and engine room side cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A005RNJ

      Remove the 2 nuts and engine cover.

  5. REMOVE AIR CLEANER CAP AND HOSE


    1. A005VS4

      Disconnect the mass air flow meter connector and wire harness.

    2. Disconnect the purge VSV.

    3. A005VYI

      Disconnect the No. 2 ventilation hose from the cylinder head cover.

    4. Disconnect the No. 2 fuel vapor feed hose from the air cleaner hose.

    5. Squeeze the tabs of the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

    6. A005R8E

      Unfasten the 3 hook clamps, and then remove the air cleaner cap and hose.

  6. DISCONNECT FUEL TUBE

    A00DPJXE02

    Note

    Do not forcibly bend or twist the fuel main tube.


    1. Remove the fuel tube from the fuel hose clamp.

    2. Remove the fuel pipe clamp.

    3. Wipe off any dirt on the fuel tube connector.

    4. Hold the fuel tube connector and install SST.

      SST
      09268-21010

    5. Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST.

    6. Insert SST into the fuel tube connector and hold it. Then push the fuel tube connector toward SST.

    7. Mount the retainer of the fuel tube connector onto the chamfered part of SST.

    8. A00DUB5E14

      Slide SST and the fuel tube connector together towards the fuel tube until they make a "click" sound, and then disconnect the fuel tube.

    9. Drain the fuel remaining inside the fuel tube.

    10. Cover the fuel tube and fuel pipe with a plastic bag to protect the disconnected parts.

      Text in Illustration
      *1 O-Ring
      *2 Retainer
      *3 Nylon Tube
      *4 Housing
      *5 Pipe

  7. DISCONNECT NO. 2 VENTILATION HOSE


    1. A00DTH5E01

      Disconnect the No. 2 ventilation hose from the ventilation valve.

  8. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY


    1. A00DRZT

      Disconnect the 2 wire harness clamps.

    2. Disconnect the 4 fuel injector connectors.

    3. A00DT2U

      Remove the 2 bolts and pull out the fuel delivery pipe together with the 4 fuel injectors.

      Note

      Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

    4. A00DUG5

      Remove the 2 delivery pipe spacers from the cylinder head.

    5. Remove the 4 insulators from the cylinder head.

  9. REMOVE FUEL INJECTOR ASSEMBLY


    1. A00DT90E01

      Pull the 4 fuel injectors out of the fuel delivery pipe.