DOOR CONTROL RECEIVER (for Sedan) REMOVAL


  1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    A003ATB

    1. Detach the 2 front hooks of the seat cushion from the vehicle body.

      Note

      Follow the instructions below carefully as the cushion frame deforms easily.


      1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

      2. Repeat for the other hook.

    2. Detach the 2 rear hooks of the seat cushion from the seatback.

      Note

      Be careful not to damage the vehicle body.

  2. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    A003CVN

    1. Remove the bolt and disconnect the rear seat 3 point type belt anchor.

    2. A003AHX

      Using a screwdriver, detach the claw to open the cap of the rear seat shoulder belt guide.

    3. Remove the seat belt from the belt guide.

    4. A003CZ2E01

      Remove the bolt, and then remove the side seatback LH as shown in the illustration.

  3. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  4. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)

    A005TDE

    1. Disconnect the connector.

    2. Remove the 4 clips.

    3. Detach the 2 clips and raise the front portion of the package tray trim panel assembly.

    4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    5. Detach the 5 claws and remove the package tray trim panel assembly.

  5. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)

    A005TDE

    1. Disconnect the connector.

    2. Remove the 4 clips.

    3. Detach the 2 clips and raise the front portion of the package tray trim panel assembly.

    4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    5. Detach the 5 claws and remove the package tray trim panel assembly.

  6. REMOVE NO. 1 ROOM PARTITION BOARD

    A005VNN

    1. Remove the 4 clips.

    2. Using a moulding remover, detach the 4 clips and remove the partition board.

  7. REMOVE DOOR CONTROL RECEIVER

    A003BZ6E01

    1. Disconnect the connector.

    2. Remove the bolt and receiver.