GENERATOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A005RE1

      Remove the clip and engine room side cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A005SU5

      Remove the 8 clips and radiator support opening cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR ENGINE UNDER COVER RH


    1. A005V2G

      Remove the 5 clips and under cover RH.

  5. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A005W8Q

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  6. REMOVE V-RIBBED BELT


    1. A005T5NE01

      Loosen bolts A and B.

    2. Loosen bolt C and remove the V-ribbed belt.

      Note

      Do not loosen bolt D.

  7. REMOVE GENERATOR ASSEMBLY


    1. A005SIG

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the connector and wire harness clamp.

    4. A005UGX

      Loosen the 3 bolts.

    5. A005SPL

      Remove the 2 bolts and adjusting bar.

    6. A005RGN

      Remove the bolt and generator.

    7. A005TRR

      Remove the bolt and wire harness clamp bracket.