CRANKSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR

    A00DUGRE05

    Note

    Make sure that the O-ring is not cracked or jammed during installation.


    1. Apply a light coat of engine oil to the O-ring of the sensor.

    2. A00DSE5E01

      Install the sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    3. Connect the 2 connector clamps.

    4. Connect the wire harness to the wire harness clamp bracket.

      Text in Illustration
      *1 Wire Harness Clamp Bracket

    5. Connect the sensor connector.

  2. INSTALL GENERATOR ASSEMBLY


    1. Install the generator Click here.