CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CAMSHAFT POSITION SENSOR

    A00DS1IE04

    Note

    Make sure that the O-ring is not cracked or jammed during installation.


    1. Apply a light coat of engine oil to the O-ring of the sensor.

    2. A00DQ47

      Install the sensor with the bolt.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

    3. Connect the sensor connector.

  2. INSTALL AIR CLEANER CAP


    1. A00DTIW

      Insert the hinge part of the air cleaner cap and hose into the air cleaner case, and then fasten the 3 hook clamps.

    2. A00DSN2E01

      Align the matchmarks of the No. 1 air cleaner hose and throttle body. Then connect the No. 1 air cleaner hose to the throttle body and push apart the tabs of the No. 1 air cleaner hose clamp.

      Note

      Make sure that the hose clamp is at the correct angle.

    3. Connect the No. 2 fuel vapor feed hose to the air cleaner hose.

    4. Connect the No. 2 ventilation hose to the air cleaner hose.

    5. A00DTX1

      Connect the purge VSV.

    6. Connect the wire harness and mass air flow meter connector.

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A00DS8Z

      Install the cover with the 2 nuts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }